Front and Rear Seats Raising/Lowering the Rear Center Head 2. Press down on the head support until you Support hear it click into place. To raise the head support, lift it until you hear 3. Pull up on the head support to ensure that it click into place. Push down on the head it is secure. support to ensure that it is secure. Warning: Ensure that the head To lower the head support, press and hold the support is installed properly before button on the outer base of the right post and anyone occupies the rear center seat. press the head support down. Failure to do so increases the risk of injury or death if a collision occurs. Seat Heaters The front seats are equipped with heating pads that operate at three levels from 3 (highest) to 1 (lowest).To operate the seat heaters, see Climate Controls on page 84. Warning: To avoid burns resulting from prolonged use, individuals who have peripheral neuropathy, or whose capacity to feel pain is limited because of diabetes, age, neurological injury, or some other condition, should exercise caution when using the climate control system and seat heaters. Removing/Installing the Rear Center Head Seat Covers Support Warning: Do not use seat covers on To remove the head support: Model 3. Doing so could restrict deployment of the seat-mounted side air 1. Raise the head support (see Raising/ bags if a collision occurs. It can also Lowering the Rear Center Head Support reduce the accuracy of the occupant on page 20). detection system. 2. Press and hold the button on the outer base of the right post. 3. Insert a short, flat object (such as a small flathead screwdriver) into the opening on the inside base of the left post and pull the head support upwards. To install the head support: 1. With the front of the head support facing forward, insert both posts into the corresponding holes on the backrest. 20 Model 3 Owner's Manual